So now that I have a bodice sloper, I really wanted to make a wrap knit dress. I found a sample on Pinterest that I really liked. It was New Look 6429, which was out of print but I think I can mimic it pretty easily.
So first I trace my bodice sloper front, drawing in the princess seam style line to the cross front through the waist darts. I flipped over the front to extend it across the center. The center front is going to be a wrapped cross front, tying into the princess seams. I redrafted the neckline to slope across. I moved the shoulder line out from the high neck point ½ inch. I added notches to aid in matching the pieces.
Next I trace the back sloper and draw in the princess style lines and open the neckline out by ½ inch just like the front. I also eliminated the back shaping.
Then I manipulate out the shoulder darts. Suzy Furrer, in her pattern drafting book, describes doing these steps first before removing the ease and adjusting the pattern for a knit. I also manipulate out the bust darts and the waist shaping.
I flipped the front centerpiece over and traced it. Then I slashed and spread between the notch just below the bust and the notch just below the waist. The right front will be gathered into the princess seam. The left front will be underneath and only go to just below the waist.
Then I draw out the skirt on each piece by drawing out 24 inches from the waist. I wanted the hemline just below the knees. I also selected a point 2 inches below the low hipline where the skirt starts to angle out. I wanted it to skim the waist and hips then flare out at the bottom. I made the final hemline width twice the waist width on each piece. I may have to adjust this some for more flare.
Now I have to remove the ease on the side seams. Plus I checked the shoulder seams to make sure it matched. Now on to the sample!